DISCONTINUED
Bobrick 748 Eclipse Automatic Hand Dryer
The Designer Eclipse by Bobrick features Chrome steel cover with automatic activation and is surface mounted for virtually any application
- Contemporary Design
- No touch Operation
- Vandal Resistant
- Surface Mount
- 10 Year Warranty
- Vitreous enamel, drawn-steel cover, white only.
- 115V AC, 20 Amp, 2400 Watts, 50/60 Hz, cULus Listed.
- 208-240V AC, 9-10 Amp. 1900-2300 Watts, 50/60
- Limited warranty: motor brushes for 3 years; all other parts for 10 years.
- Installation: Automatic hand dryers should be installed 15" (380mm) above any projection or horizontal surface which may interfere with the operation of the automatic sensor.
- Cover — One-piece, deep-drawn, 16-gauge (1.6mm) thick steel finished in high-gloss, acid-resistant vitreous enamel or bright polished chrome-plated finish. Cover is secured to mounting base by a retaining bracket and to the air inlet/outlet grille by a single concealed locking screw
- Air Inlet/Outlet Grille — Vandal-resistant, pressure die-cast aluminium. Includes infrared sensor and operational graphics. Fixed to the mounting base by two screws and to the cover by one screw
- Mounting Base — 16-gauge (1.6mm) thick plated-steel with three 1/4" (6mm) diameter mounting holes and one 7/8" (22mm) diameter hole for electrical supply wiring
- Fan — Dynamically balanced, single inlet, directs air flow in a wide band through heating element at 105 cfm
- Motor — Universal, 1/10 hp, 6200 rpm with sealed ball bearing at drive shaft end and self-lubricating sleeve bearing at nondrive end. Equipped with automatic thermal-overload switch
- Heating Element — Coiled nickel-chrome wire is mounted on mica formers and equipped with automatic thermal-overload switch. Black, injection molded element housing is mounted on the fan inlet, heats air without hot spots—inaccessible to vandals
- Electronic Control — Infrared automatic sensor automatically turns dryer on when hands are held under air-outlet opening and across path of sensor. Remove hands from path of sensor and dryer stops. Electronic sensor has automatic shutoff approximately 1-1/2 minutes after dryer turns on if an inanimate object, such as tape or chewing gum, is placed across sensor lens. After inanimate object is removed, electronic sensor automatically resets itself and dryer operates normally
