BOBRICK B6867

Features
Satin-finished stainless steel. Support-arm flanges lock to concealed stainless steel wall plate. Chrome-plated plastic spindle holds rolls up to 5-1/2" (140mm) dia. (1800 sheets). Theft-Resistant Spindle (Part No. 283-604) available as replacement part.

MATERIAL:
Flanges and Support Arms (3) -— 18-8 S, type-304, 22-gauge (0.8mm) stainless steel. Concealed, 16-gauge (1.6mm)
stainless steel mounting bracket is welded inside each flange. Secured to wall plate with setscrew.
Concealed Wall Plates (3) — 18-8 S, type-304, 16-gauge (1.6mm) stainless steel.
Spindles (2) — Chrome-plated plastic. Equipped with heavy-duty internal springs.
Designer's Note: Theft-resistant spindles, which are removable only with special key provided, are available as optional
accessories. To specify, add suffix .60 to model number. Example B-686.60.

INSTALLATION:
To remove concealed wall plates from back of flanges and mounting brackets, loosen setscrews. Mount each wall plate with
prongs at top; secure with sheet-metal screws furnished by manufacturer at points indicated by an S. Engage mounting
brackets onto prongs of wall plate, then secure into position by tightening setscrews at bottom of flanges.
Note: Center-to-center of concealed wall plates must be within 1/16'' (1.6mm) of dimension shown.
For partitions with particle-board or other solid core: Secure with sheet-metal screws furnished by manufacturer or provide
through-bolts, nuts, and washers.
For hollow-core metal partitions: Provide solid backing into which the furnished sheet-metal screws can be secured. If two
units are installed back-to-back, then provide threaded sleeves and machine screws for the full thickness of partition.
For masonry walls: Provide fiber plugs or expansion shields for use with sheet-metal screws furnished by manufacturer, or
provide 1/8'' (3mm) toggle bolts or expansion bolts.
For plaster or dry wall construction: Provide concealed backing to comply with local building codes, then secure the unit
with sheet-metal screws furnished.

SPECIFICATION:
Double-roll toilet tissue dispenser shall be type-304 stainless steel with _______________ (insert one: bright polished or
satin) finish. Unit shall accommodate two standard-core toilet paper rolls up to 5-1/2'' (140mm) diameter (1800 sheets).
Flanges shall be equipped with concealed, 16-gauge (1.6mm) stainless steel mounting brackets that are secured to concealed
stainless steel wall plates with stainless steel setscrews. *Spindles shall be equipped with a heavy-duty internal spring.